How do I program my Jandy Aqualink?
Basic Programming: To set a particular piece of equipment to turn on and off at a predetermined time, press the MENU button, press the forward arrow button to scroll to the PROGRAM menu, press ENTER, and then press the button for the equipment that you want to program.
Where is the pressure sensor on the Jandy JXI pool?
The middle circle is the pressure sensor I referred to and it was the one that caused my connection problems. The pressure sensor that senses flow is located inside the panel that covers the PVC piping. The flue gas vent sensor is in the remaining circle near the large pipe that exits close to the black vent fitting.
What happens when you turn on a Jandy pool heater?
The normal sequence after you turn on the heater is the temp setting is detected above the actual temp. Then the control board checks for hi/lo temp, water pressure, vent fire sensor, then it issues “call for heat” to the ignition control. Then the blower starts and the ignition module checks pressure senor.
How to check the salinity of a Jandy pool?
•The system will display the salinity reading, press the up arrow to increase the reading and the down arrow to decrease the reading. •When the proper reading is reached press the “Temperature” button within 5 seconds to store it in memory. 15 Transformer Voltage on Rev. 2 backboard Reading the AC voltage between T.P.-
What are the parts for a Jandy pool heater?
From ignition control assemblies to heat exchangers, we have the Jandy replacement parts you need to get your pool or spa heater up and running in no time. We carry a wide selection of Jandy pool heater parts for the Lite 3, LX, LT, HI-E2, CL-3, LXI, Legacy and Hot Shot series pool heaters.
What kind of gas valve for Jandy Lite 2?
Whether you’re looking for Jandy Lite 2 pool heater parts or a gas valve for a Legacy pool heater, we have what you need and can ship it when you need it. Teledyne Laars L0032200 Gas Orifice, Natural, 0-2000 ft. Teledyne Laars L0032900 Gas Orifice, LP, 0-5000 ft.
•The system will display the salinity reading, press the up arrow to increase the reading and the down arrow to decrease the reading. •When the proper reading is reached press the “Temperature” button within 5 seconds to store it in memory. 15 Transformer Voltage on Rev. 2 backboard Reading the AC voltage between T.P.-
