How do I program AquaLink panel?
Basic Programming: To set a particular piece of equipment to turn on and off at a predetermined time, press the MENU button, press the forward arrow button to scroll to the PROGRAM menu, press ENTER, and then press the button for the equipment that you want to program.
How do I reset my PDA AquaLink?
Turn “LEARN” to the off position, and hit the reset button inside the jbox. This will reset the connection. If this does not work for you, turn the power off completely to your power center at the breakers.
Who is the AquaLink PDA pool digital assistant?
AquaLink®RS PDA – Pool Digital Assistant H0572300D WARNING FOR YOUR SAFETY: This product must be installed and serviced by a pro fes sion al pool/spa service technician. The procedures in this manual must be followed ex act ly. Failure to follow warning notices and instructions may result in property damage, serious injury, or death.
Who is required to install an Aqualink pool?
FOR YOUR SAFETY: This product must be installed and serviced by a pro fes sion al pool/spa service technician. The procedures in this manual must be followed ex act ly. Failure to follow warning notices and instructions may result in property damage, serious injury, or death.
What are the safety instructions for Aqualink Rs?
Section 1. Important Safety Instructions READ AND FOLLOW ALL INSTRUCTIONS LIRE LA NOTICE TECHNIQUE. All electrical work must be performed by a licensed electrician and conform to all national, state, and local codes. When installing and using this electrical equipment, basic safety precautions should always be followed, including the following:
What is the serial number on an Aqualink filter?
DATE OF INSTALLATION INSTALLER INFORMATION INITIAL PRESSURE GAUGE READING (WITH CLEAN FILTER) PUMP MODEL HORSEPOWER FILTER MODEL SERIAL NUMBER PDA HANDHELD REMOTE MODEL SERIAL NUMBER NOTES: EQUIPMENT INFORMATION RECORD Section 1.
How many wires does Jandy Aqualink Rs board have?
The Aqualink RS board has one or two RS-485 connections. You can connect at least 2 sets of wires to each RS-484 connection. Depending on if your panel has 1 or 2 ports you can have 2 or 4 devices hooked up Jandy has the #6584 Multiplex PCB Kit for connecting more than 2 sets of wires.
Can a Jandy Aqualink Rs control an IntelliFlo vs pump?
While the Aqualink RS can control an Intelliflo VS pump it cannot control the VF functions of a VSF pump. At one time Jandy’s F/W was made to talk with the IntelliFlo VS.
What’s the difference between Aqualink PDA and Aqualink Rs?
Aqualink RS is the full featured version of the Aqualink product line. There are also the AquaLink PDA and Aqualink Z4 products that have different control devices, user interfaces, and functionality. This Jandy Automation Selection Guide shows the family of modular components across the different Aqualink models – RS, PDA & Z4.
How to enable spillover control on Jandy pool?
If a non-booster pump cleaner is installed, plug the JVA into the cleaner JVA socket. If you have a pool and spa you can enable the Spillover function with dip switch #3 on the main panel. When switch #3 is on then AUX3 becomes the spillover control.
