How do I permanently level my camper?

How do I permanently level my camper?

How to Level a Travel Trailer on a Permanent Site

1. Step 1: Choose and Prepare Your Site.
2. Step 2: Check Your Travel Trailer With A Level.
3. Step 3: Place Leveling Blocks Near Your Travel Trailer’s Tires.
4. Step 4: Carefully Drive The Travel Trailer Onto The Leveling blocks.

Is there a problem with the Jacks down alarm?

We have been having a problem with the jacks down alarm. This happened as we were driving down the interstate a couple of years ago. The jacks were up but the alarm kept sounding. The dealer said that everything was fine and we didn’t have any further problem until now. We retract the jacks and visually they seem to be all the way up.

Why does my HWH alarm keep going off?

The reason I ask, the HWH jacks on our coach will do that if I turn them off after the jacks initially come up and the alarm goes off vs the correct way of letting the system turn itself off. Letting it turn itself off allows a few minutes for all the extra fluid in those long lines to the back jacks to bleed back into the reservoir.

Why does my Kwikee alarm keep going off?

There is a pressure adjustment, but it must be within specifications. The Kwikee system has a reed switch on the top of each jack. If it is bad it will also cause the “jacks down” alarm to sound. On the back of the Kwikee control board there is a 4 pin plug.

How to troubleshoot LCI leveling system troubleshooting panel?

Troubleshooting Panel of LCI Leveling System that Has Down Light that Stays on All the Time Front Jack Legs On Lippert Ground Control Lower When Slide Is Used Setting Up Lippert Ground Control 3.0 After Installing Replacement Control Module

We have been having a problem with the jacks down alarm. This happened as we were driving down the interstate a couple of years ago. The jacks were up but the alarm kept sounding. The dealer said that everything was fine and we didn’t have any further problem until now. We retract the jacks and visually they seem to be all the way up.

The reason I ask, the HWH jacks on our coach will do that if I turn them off after the jacks initially come up and the alarm goes off vs the correct way of letting the system turn itself off. Letting it turn itself off allows a few minutes for all the extra fluid in those long lines to the back jacks to bleed back into the reservoir.

There is a pressure adjustment, but it must be within specifications. The Kwikee system has a reed switch on the top of each jack. If it is bad it will also cause the “jacks down” alarm to sound. On the back of the Kwikee control board there is a 4 pin plug.

Troubleshooting Panel of LCI Leveling System that Has Down Light that Stays on All the Time Front Jack Legs On Lippert Ground Control Lower When Slide Is Used Setting Up Lippert Ground Control 3.0 After Installing Replacement Control Module