How do I manually retract LCI electronic leveling?
How to Enter Manual Mode – Retract:
- Push “ON/OFF” to turn the system on.
- Push the “UP” arrow once, or until the screen reads “MANUAL MODE”.
- Push the “ENTER” button once.
- Push the “RETRACT” button, the red LED light will turn on.
- Push the “REAR” button to retract all of the middle and rear landing gear legs.
Why is my Lippert ground control leveling not working?
I dont know if the leveling system is a 2.0 or 3.0. The display on the touch pad is blank. The back light comes on, but no words, It seems like everything else works, I can press the auto level button and it works. I can press the retract button and retract the landing jacks, I just cant see anything on the display.
How does the Lippert electronic leveling system work?
The Lippert Electronic Leveling System is an electric/hydraulic system. A 12V DC electric motor drives a hydraulic pump that moves fluid through a system of hoses, fittings and jacks to level and stabilize the coach. The Lippert Electronic Leveling System is totally integrated into the chassis of the coach at the manufacturer.
What to do if your Lippert LCD is not working?
Before replacing the third one, I recommend unplugging the connections on the panel and cleaning them prior to reconnecting. If this doesn’t solve your problem, then I recommend the Replacement Auto Level Control Panel for Lippert Ground Control Leveling System # LC421484 to give you the working LCD display.
How to troubleshoot LCI leveling system troubleshooting panel?
Troubleshooting Panel of LCI Leveling System that Has Down Light that Stays on All the Time Front Jack Legs On Lippert Ground Control Lower When Slide Is Used Setting Up Lippert Ground Control 3.0 After Installing Replacement Control Module
How can I Reset my Lippert LCI leveling system?
My Lippert LCI leveling system is showing jacks down when the jacks are up. All the lights start blinking with break off and ignition on. Cannot lower jacks. Reset by pushing all four buttons just stops it for a second then lights start blinking again. Checked fuses. After a few minutes just the lights on left side blink.
How can I check the fluid level on my LCI?
Reset by pushing all four buttons just stops it for a second then lights start blinking again. Checked fuses. After a few minutes just the lights on left side blink. Trans fluid level is hard to check as it is transparent on the dip stick. But the see through fluid tank shows level is about an 1-1/4 in below top of tank.
How long does it take to reset a LCI controller?
It requires 5 seconds, but many people will count to 5 a little too fast and the system won’t reset. He said if that doesn’t work then the controller is bad and will need to be replaced.
