How do I know if my spa heater is working?

You test the element by using an Ohm meter, or any multi-meter will work also. Just place it on Ohms, at 1000, and place your test leads on each of the terminals (power to spa heater should be off). As mentioned above, a measurement of 9-12 Ohms of resistance usually indicates a good element.

How does a spa heater work?

An electric resistance spa heater creates heat by applying an electrical current to a heating element, which is a metal resistor. The resistor extends throughout assembly housing inside the unit. The resistor heats when a current is applied to it.

What kind of heater does Great Lakes Spa use?

We offer every type of replacement heater for Great Lakes spas whether you have a Gecko or Balboa control system installed. For instance, we offer the Gecko IN.XE 4kW 240V heater. These are all factory original Emerald/Great Lakes replacement heaters.

Are there replacement parts for Great Lakes spas?

Not as a guarantee of results. Great Lakes Spas Parts listed are NON- BRANDED equivalent parts ( Generic replacement parts ) from same part manufacture. Others are Replacements that will work as well or better. The listing is meant as a aid in helping you find your replacement parts faster. Not as a guarantee of results.

How big is the Great Lakes hot tub?

The largest Great Lakes Spa model, the GL8, was 90″ square with 60 jets and room for up to 8 persons. Contact us at [email protected] if you need assistance in finding the right spa part or accessory for your Emerald Spa hot tub – send details/part number/even a picture along with your request if you like.

What kind of jets do great lakes spas use?

These are all factory original Emerald/Great Lakes replacement heaters. We offer a wide variety of replacement Great Lakes jets, valves, suctions and plumbing parts. Replacement jets available in graphite or stainless steel finish. Jets are available in gray and stainless steel for most Great Lakes spas.