How do I know if my chlorinator cell is working?
The easiest way to be certain if the chlorinator is working is to make sure the cell is clean by checking the needle or production lights on the chlorinator box. When operating, you should also see bubbles (hypochlorite gas) inside the chamber, producing what looks like cloudy water – that’s chlorine being created!
What causes a pool chlorinator to indicate no flow?
other debris may be deposited on it and cause it to indicate a low salt or no flow condition. Should a low salt condition be indicated, have your salt level checked at your local pool shop. If the low salt condition persists, or a no flow condition is indicated when the supply pump is
Why does the Red flow light come on when making chlorine?
Seems like there are no obstruction, so the flow switch is the problem, I would think. The “cell” light will only come on when it’s making chlorine. If the red flow light is lit, the SWCG “thinks” there is little or no water flowing through it and will no operate, no matter what. If it’s under warranty, give Pentair a call.
What happens if you run a salt water chlorinator without salt?
If you run the saltwater chlorinator without enough salt, it can damage the electrodes. Get the water tested by a pool service company that can advise you on the quantity of salt in the pool and other elements like pH, alkalinity, and calcium.
Why does my hurlcon chlorinator keep saying no flow?
In the last few months, my the ‘no flow’ indicator on my Hurlcon chlorinator keeps lighting up. I discovered that one of the leads in the chlorinator is covered by a white layer and needed cleaning with acid solution. The thing is this is happening quite frequently. After the last cleaning, the no flow indicator lit up again only after a few days.
Seems like there are no obstruction, so the flow switch is the problem, I would think. The “cell” light will only come on when it’s making chlorine. If the red flow light is lit, the SWCG “thinks” there is little or no water flowing through it and will no operate, no matter what. If it’s under warranty, give Pentair a call.
What does the chlorinator off no flow message mean?
Within minutes, the “Chlorinator Off No-Flow” message went away, and the only messages remain are as follows: “Chlorinator Off – Low Temperature”, and “Check System – Low Salt”. I have the following Temperature readings: Pool Temp: 57 Degrees F, Cell Temp Sensor: 58 Degrees F, Water Sensor: 57 Degrees F, Air Sensor: 57 Degrees F.
What does red light mean on pool pump?
If the light is red, that means that there is insufficient flow via the cell for the right operation. Check to ensure that the pool pump is switched on and the water is flowing freely. If you detect insufficient flow, then uninstall the cell and inspect the flow switch situated in the front part of the cell to guarantee proper operation.
What should I do if my pool chlorinator says no flow?
Should a low salt condition be indicated, have your salt level checked at your local pool shop. operating, you may need to manually clean your chlorinator Cell. PH and TA is a bit high but CA is on the low end so calcium shouldn’t really drop out of solution but maybe the negative charge makes it worse.
