How do I get rid of Aqualisa Aquastream?
Insert a small flat headed screwdriver into the screwdriver slot taking care not to damage the surrounding plated surfaces and carefully remove the Aquastream Thermo control knob from the unit by pulling it away from the product.
How do you bleed an electric shower?
There is not a purge button on the elite, if you take off the shower head lay the hose in the bath, turn control to full cold, switch power temp setting to low, then turn on the power to the unit and press the start button. Allow 5-10 seconds for water to come through. This is the correct way to bleed the shower.
How do you change air lock holder on Aqualisa?
Once the cable is in the room with you, you can slide the old holder off the top of the rail and over the data cable, and reverse to fit the new holder. As this is a technical job we usually recommend an Aqualisa service engineer carries out this work. HOW DO I CLEAR AN AIR LOCK?
What should I use to clean my Aqualisa shower?
To avoid rapid scale build up, we advise that after use you tilt the shower head at an angle, which will allow any excess water to drain away. When cleaning an Aqualisa product, we advise that you use warm soapy water or non-abrasive bathroom cleaning products. HOW DO I REGISTER MY WARRANTY? You can register your shower by clicking on this link.
Where to disconnect data cable on Aqualisa shower?
You will need to isolate the power and water to the shower, disconnect the data cable at the processor unit / Quartz™ smart valve and then disconnect the black push fit 90° elbow located directly above the shower, fitted to the shower’s down pipe.
Where do you find the model on an Aqualisa shower?
The majority of Aqualisa showers do not have a name or model written on them but if you have an Aqualisa electric shower, the model will be inscribed on the front cover or possibly on the Aqualisa badge. Alternatively you can contact our Customer Care team by e-mail and attach some photographs of the product for us to identify.
How to remove an airlock on an Aqualisa shower?
To remove an airlock remove the head and lower the hose into the bath/shower tray, turn the water on with the temperature dial all the way to cold, then slowly turn it the opposite way. Waiting for any splutters which will be the air bubble being released.
What to do if your Aqualisa shower is not working?
This will reduce the pressure required to get water back through the system to the absolute minimum. Next simply turn the dial to the coldest setting then turn the shower on. Let it run for a few seconds and hopefully you’ll get some spluttering of water out of the hose. If not, turn the shower off, wait a few seconds and try again.
How is the Aqualisa gravity pumped power shower rated?
Thermostatic power shower with bi-metallic valve technology. Designed specifically for low pressure plumbing systems. Integrated booster pump. Add to basket for… Aqualisa Aquastream Gravity-Pumped White Thermostatic Power Shower is rated 4.5 out of 5 by 4 . Add to saved list…
How does an Aqualisa thermo shower system work?
Like all of our Thermo showers, Aqualisa Aquastream Thermo relies upon our proven thermostatic showering technology. Two flow rate settings allow you to make the most of your plumbing system and thanks to Aqualisa Aquastream Thermo’s surface mounted design, installation is easy, with damage to décor being kept to a minimum.
