How do I get my spa off sleep mode?

Locate and open the panel with your pool or hot tub pump timer. This should be located close to the pool pump itself and the hot tub. Set the on and off switches to the desired times. Disengage the time dial and set it to the current time.

What mode should hot tub be in?

By default filter modes are 2 hours in the morning and 2 hours in the evening, the rest of the time the hot tub will use the insulation to keep the spa warm and retain heat. Economy is a good setting for those who use the hot tub daily.

Can you run your hot tub without a filter?

Don’t Run It Without the Filter Running the pump in a spa for too long without a filter can lead to clogged pump impellers and a fast decline in the water quality. So if you need a new filter, replace it as soon as possible. And in the meantime, only run the pump on low speed instead of turning it off.

What does it mean when your Spa is in sleep mode?

“Ec” or “Ecn” will appear solid when the temperature is not current and will alternate with the temperature. Sleep mode heats the spa to within 20 F (11 C) of the set temperature only during filter cycles. “Sl” or “SLP” will appear on the display until mode is changed.

How to get a hot tub to exit SL sleep mode?

On them you need to press the ‘TEMP’ button and then the ‘LIGHT’ button within three seconds of each other and this will change the modes from EC (economy mode), to SL (sleep mode) and finally to ST (standard mode) which is what you want. Read full interaction below » Ask Your Own Pool and Spa Question Share this conversation Resolved Question:

When do I Turn on Economy mode on my spa?

Note that the last measured spa temperature displayed is current only when the pump has been running for at least 1 minute. “St” or “Std” will appear on the display momentarily when you switch into Standard Mode. Economy mode heats the spa to the set temperature only during filter cycles.

What happens when the hot tub is in filter mode?

The temperature of the hot tub will be reach & maintained when in standard mode. The hot tub will only use the heater when the spa is in “filter mode” and the water has encountered a drop in temperature below the standard thermostat setting.

When to use standard mode or sleep mode?

We were told that if we wanted to keep the spa going 24/7 we can set it to standard mode during the day, and sleep mode at night. The filter will be going still, but the heater heats less often, and the jets only go every few hours rather then every hour or so in standard mode.