How do I fix my jandy PDA?
patpend
- Open the PDA. At first glance the PDA looks pretty impenetrable with its overmolded rubber housing, but actually, the front panel comes off fairly easily.
- Remove the membrane.
- Repair the buttons.
- Restore the contacts.
- Reassemble and test.
Why did my Jandy pool PDA stop working?
When the “Back” button died completely the PDA became essentially unusable. Since the PDA is the only means of controlling my pool I had no choice but to replace it. With new PDAs going for $300 I figured I had nothing to lose by trying to fix the old one. The results were better than expected, and the PDA now works as good as new.
How much does it cost to fix a Jandy PDA?
With new PDAs going for $300 I figured I had nothing to lose by trying to fix the old one. The results were better than expected, and the PDA now works as good as new. Total cost was about $15 which is a heck of lot less than a new PDA.
How can I fix the keypad on my Jandy PDA?
It also works on TV remotes, phones, calculators, computer keyboards – any device that uses rubber membrane technology. To use “Keypad Fix” just follow the directions. Clean the pads (circled in red) gently with isopropyl alcohol on a swab and let dry. Stir “Keypad Fix” well, then apply a thin coat with a swab.
What kind of phone do I need for Jandy?
I have a Samsung Galaxy S5 phone which is water-resistant and use this to control my Jandy automation though an iAqualink phone app poolside. That could be useful, but you need the aqualink interface to go with it. Not even sure if the system at my potential new home can be upgraded to that.
Why is my Jandy PDA stuck on waiting?
Cycle the computer My Jandy PDA is also stuck on waiting. Cycle the computer power breaker and it connects as usual. Power PDA off and on again, stuck in waiting. … read more
Why does my Jandy PDA model 8265 not work?
My jandy PDA model 8265 is stuck opn waiting. I’ve tried changing the RF Channel but no response from the Jbox … read more I have a Jady Aqualink RS PDA. I’ve had it years now working I have a Jady Aqualink RS PDA. I’ve had it for 3 years now working fine. It turned on the hot tub and then showed handheld:3.0 Battery:ok RF … read more
With new PDAs going for $300 I figured I had nothing to lose by trying to fix the old one. The results were better than expected, and the PDA now works as good as new. Total cost was about $15 which is a heck of lot less than a new PDA.
Is the Jandy Aqualink control panel lit up?
I have a Jandy Aqualink system. The control panel is 99% lit up and frozen, with the exception of the pool mode light which is not on. The buttons … read more I have a jandy power center PCB 8124a. It will not power the i have a jandy power center PCB 8124a. It will not power the filter pump module … read more
