How do I fix HL error on hot tub?
HL Error
- Turn the power off at the breaker for 15 seconds and then flip it back on. This will reset the HL reading.
- You will notice the display show some numbers.
- If you see the HL come back within a day or so, this means that there is likely a problem with the probe or the motherboard.
Why does my hot tub says HL?
When “HL” error message displays, it means the system shut the heater down because temps at the heater reached 119ºF (48ºC). When “HL” error message is flashing, it means the system shut down because the water temps in the spa reached 112ºF (44ºC). In this condition, only Smart Winter Mode will remain active.
What does HL mean on a clever spa?
An HL error usually means there is a blockage, preventing water from circulating around the pump & heating system.
How much does a clever spa cost?
How much will it cost me to run a CleverSpa ®? 14.5 x 1.8 = 0.26 x 11.3 = £2.94 to heat up the water. If we take an average, then we could estimate that it will cost approximately £2.58 to heat up the water in the hot tub.
How to access low level programming on coast spas?
To access low level programming, press and hold Programkey for 20 seconds, after which the first parameter code should appear on the display. Use Up/Downkeys to modify parameter values and Programkey to change from one parameter to the next. You must go through all parameters to exit this mode.
What is the coast spas TSPA-MP service manual?
COAST SPAS TSPA-MP SERVICE MANUAL • Gecko Electronics Inc. • Visual step-by-step guide to easily identify & correct technical problems! Table of Contents Power & Ground Check Electrical Wiring 4 GFCI 5 Error Conditions
What does the code OH mean on a hot tub?
OH : Overheat. Spa temp over 108°. HLoH : Hi Limit Over Heat. Hi limit sensor is disconnected, shorted, or spa temp is above 112° F. SEoP : Sensor open or disconnected. Heater disabled but spa operational. SESH : Sensor short, nonfunctional. Heater disabled but spa operational.
How old should a coast spa pump be?
Over time a worn pump seal or defective pump may necessitate the replacement of pump seals or the entire pump. Usually if a pump is over 3-4 years old, it may be best to just switch out the entire pump instead of trying to just fix the motor. Do note that wet-ends can be replaced on
Where do I find the serial number on my coast Spa hot tub?
Contact us if you just need a pump part or wet end. Send us a picture of your pump label and pump for easy identification. Include your spa serial number if you can find it on the serial number plate near the equipment bay. We offer the C2400-0800ET-G 4kw heater used in select Coast spas as well as many more.
To access low level programming, press and hold Programkey for 20 seconds, after which the first parameter code should appear on the display. Use Up/Downkeys to modify parameter values and Programkey to change from one parameter to the next. You must go through all parameters to exit this mode.
What kind of pump does a coast Spa use?
Compatible control panels include the Balboa VL600S, VL700S, 701S and 702S as used in Elite spas. Get the 55378 Balboa TSC 3 pump control panel and others. Factory original control panels and overlays for most Coast Spas.
How many models of coast Spa hot tubs are there?
Hot Tub Outpost carries replacement spa parts for all the models of portable hot tubs made by Coast Spas. Coast Spa makes 5 series of hot tubs plus swim spas.
