How do I fix error code h2o on a spa?
H20 code (The spa has detected that there is a lack of water in the heater) 1. Check to make sure that the spa is filled with water to the correct level. 2. Press the pump button – The spa will attempt to run the pump for a few seconds to circulate water through the heater.
What causes H2O error 06 on Davey spaquip spa sensor?
Davey Spa-Quip Spa Power Optical Wate… Davey SpaQuip Spa Power Optical Water Sensor. Common source of Error 06, or H2O faults on Davey SpaQuip Spa Power controllers such as the Davey SpaQuip Spa Power 400, 600, 601, 750, 800, 1000, 1200. Sometimes crack with age or over-tightening. Also calcify where water chemistry has gone out of balance.
What is the manual for the sp601 and sp400p?
Download the SP601 & SP400P Installation & Instruction Manual Guide. Touch Pads. The yellow Auto indicator light will appear on the touch pad whenever the system is in full automatic control mode. In this mode the system automatically activates the pump and heater to filter the water and maintain the set water temperature.
Is there a problem with my spa pump?
-Overtemperature Thiserrorindicatesthatthedigitaltemperaturesensorintheheaterorpoolhasdetectedatemperatureof45 Cormore.Thismaynotbea problem with the SP601, it may be caused by excessive pump use in hot weather, or pump failure.Turn off the spa and allow time for the watertocool.Ifthereisstillaproblemthencontactyourspapoolsupplier.
What are the error codes on the spa power controller?
8 Self-Diagnostic Error Codes The Spa Power controller has extensive self diagnostic capabilities. In the event of a problem it will indicate an error number according to the nature of the problem. The error numbers and their meanings are listed below. Note:When in an error state the alarm can be muted by pushing the AIR/AUX button.
What do you need to know about spa SP600?
This article is designed to provide all the information you need to install your SP600. Download the SP600 Installation & Instruction Manual Guide. The Spa Power 600AC/BC uses a small circulation pump which runs 24 hours a day, to circulate water through the filter and heater.
Why is my SP600 pool not working properly?
If there is still a problem then contact your spa pool reseller. This error indicates that the digital temperature sensor in the heater or pool has detected a temperature of 45 C or more. This may not be a problem with the SP600, it may be caused by excessive pump use in hot weather, or pump failure.
What does the H20 light on the spa quip mean?
The yellow or blue H20 light indicates if water is present in the heater. If no water is detected then the light will flash and the unit will not operate except to run the circulation pump to try to get water to the heater. If no water reaches the heater for one minute then an H20 error will occur.
What to do when your spa quip SP600 says Prime failed?
Note: When in an error state the alarm can be muted by pushing the AIR/AUX button. This is not necessarily a problem with the SP600 itself, but indicates that no water is being detected in the heater housing. Prime failed is a special case in that it can be recovered from by pushing a button.
