How do I calibrate my Aqualink?

How do I calibrate my Aqualink?

How to calibrate the temperature on your iAqualink Unit

1. Click on the “Pool” button.
2. Adjust the temperature using the arrow keys.
3. Click the “Back” button until you reach the home screen again.

What’s the fuse fault on my Jandy pool heater?

Fuse Link Fault/Field. It’s a Jandy Legacy LRZ 399,000 BTU,. Did some googling and didn’t find much. I found this in the troubleshooting guide FAULTFUSELINK/FIELD 1. Fusible link fault. 1. Identify and correct loose connections or replace Fusible Link… I believe the attached image points to the part needing replacement.

Where is the fuse on the Jandy LXI?

IMG_20190619_2057500.jpg is the one near the exhaust. I understand its a one time use and will burn out. It definitely doesn’t look like the other fuse, but wasn’t sure looking at it visually if its shot. I also notices the wire connections were much darker.

When do I get the fuse link fault error?

Recently getting the ‘Fuse Link Fault’ Error’. When I turn the heater on, the fan starts. A little while later it ignites and I can feel heat being exhausted off the top. 20-30s later it stops with that error. It then retries a number of times unless i turn it off.

How old is the Jandy LRZ pool heater?

Hello I have a Jandy LRZ 175,000 btu pool heater which is 9 years old. During heating process the exterior gets really hot including the display/control panel. To the point the digital display does no…

Fuse Link Fault/Field. It’s a Jandy Legacy LRZ 399,000 BTU,. Did some googling and didn’t find much. I found this in the troubleshooting guide FAULTFUSELINK/FIELD 1. Fusible link fault. 1. Identify and correct loose connections or replace Fusible Link… I believe the attached image points to the part needing replacement.

IMG_20190619_2057500.jpg is the one near the exhaust. I understand its a one time use and will burn out. It definitely doesn’t look like the other fuse, but wasn’t sure looking at it visually if its shot. I also notices the wire connections were much darker.

Recently getting the ‘Fuse Link Fault’ Error’. When I turn the heater on, the fan starts. A little while later it ignites and I can feel heat being exhausted off the top. 20-30s later it stops with that error. It then retries a number of times unless i turn it off.

Hello I have a Jandy LRZ 175,000 btu pool heater which is 9 years old. During heating process the exterior gets really hot including the display/control panel. To the point the digital display does no…