How can I tell if my aquarite needs to be replaced?
To determine if you need to replace the cell, check the water temp on your Aquarite’s control panel diagnostic’s. If the water temperature reads 215 degrees F, the cell temperature sensor is shorted and the cell needs to be replaced.
What to do with the Aqua RITE installation receipt?
Keep the original box and write the date of installation on said box. Keep the receipt from the store or installation service technician. If you purchase from a retail store, have them hand key the Model and Serial # on the receipt at the point of purchase.
When to check the salt level in aqua rite?
CHECK SALT When flashing, the salt level is low (below 2700 ppm) and Aqua Rite is generating at low efficiency. When illuminated steady, the salt level is too low and Aqua Rite has shut down. Before adding large quantities of salt, it is advisable to have your salt level professionally checked.
How to install a Hayward Aqua rite salt chlorine generator?
How to Install a Hayward Aqua Rite Salt Chlorine Generator. Step 1. Balance the pool water before installing the Aqua Rite Salt Generator. Note: If the pool does not have new water, add one quart of metal Step 2. Step 3. Step 4. Step 5.
Keep the original box and write the date of installation on said box. Keep the receipt from the store or installation service technician. If you purchase from a retail store, have them hand key the Model and Serial # on the receipt at the point of purchase.
How to check the salt level of aquarite?
If salt level is within range, go to step B. If salt level is below range, add enough salt to achieve a salt level of 3200ppm. (Refer to Salt Chart, Page 21) HAYWARD Step B Inspect and/or Clean Cell If cell looks like 4A, go to step C. If cell looks like 4B, clean cell. (Refer to Pages 12 thru 15) Page 2
How to Install a Hayward Aqua Rite Salt Chlorine Generator. Step 1. Balance the pool water before installing the Aqua Rite Salt Generator. Note: If the pool does not have new water, add one quart of metal Step 2. Step 3. Step 4. Step 5.
How to reset the inspect cell led on aquarite?
To manually reset the Inspect Cell LED, press and hold the Diagnostics button until LED goes out (approximately 3 to 5 seconds).
