How can I Reset my LCI electronic leveling system?

Our 2010 Georgetown has the LCI Automatic Leveling System and it’s a pain in the rear. After a long day on the road….get parked for the night and the darned thing won’t work.

Why is there no power on my LCI?

If nothing is getting power I’m wondering if your trailer itself is getting power. If your batteries are depleted and you don’t have your trailer electrical connected to your tow vehicle then there isn’t any power getting to your trailer and is makes sense that nothing is working.

What should the charge level be on a lead acid battery?

With lead-acid batteries, you are not supposed to drop them below a 50% charge level for maximum life. The best way to observe the correct charge level is to observe the ‘resting’ voltage (ideally with zero load and after a few hours of no use, but this isn’t practical in RV life).

What kind of leveling system does a Winnebago Brave have?

Have a 2004 Winnebago Brave with the HWH 325 series Leveling System. While driving the yellow ‘Jacks Down’ indicator light turned on and buzzer sounded, pulled over and found the LR jack was down about 1/4 inch with the round RF jack indicator on the keypad was ‘red’.

Our 2010 Georgetown has the LCI Automatic Leveling System and it’s a pain in the rear. After a long day on the road….get parked for the night and the darned thing won’t work.

Why is there a blank screen on my LCI?

The blank screen on your LCI Ground Control 3.0 could be either a power issue or a control module issue. I recommend first remove the panel and unplug it from the back leaving it unplugged for at least 15 minutes so that it loses all of the residual power and is completely shut off.

How does the Lippert electronic leveling system work?

The Lippert Electronic Leveling System is an electric/hydraulic system. A 12V DC electric motor drives a hydraulic pump that moves fluid through a system of hoses, fittings and jacks to level and stabilize the coach. The Lippert Electronic Leveling System is totally integrated into the chassis of the coach at the manufacturer.

Why does my T8 LED light keep flickering?

Many new T8 LED lamps are incompatible with older dimmers and switches. There are a number of other potential points of failure resulting in the flickering or power issues with your LED lamps, including: Incompatible switches. Driver components. Relaxation oscillator. Incorrect power/surge wattage. Changing voltage levels.

What should I do if my LED light is flickering?

Check for loose wires. Tighten and securely screw lamp correctly in place. Ensure the connection point hasn’t become loose. If the wiring is loose at the connection point, disconnect power to the circuit and secure wiring as needed. If your wiring and connections are working, the issue may be resolved by checking for incompatible switches.