How big is the etrailer landing gear set?
Atwood electric motor bolted right in. Overall very happy with the landing gear, as it was cheaper than just the replacement driver leg Atwood that was broke. 414274 This landing gear set according to the paperwork in the box is only rated at 5000# with a single motor.
How do you retract a landing gear motor?
If you have moved the motor after attaching the gearbox to the leg, ensure that both legs are the same length before proceeding. Measure the distance from the frame to the lower end of the sliding section on the opposite leg, and extend or retract the leg with the motor attached to match. 8.
Can you use landing gear to lift a trailer?
Do not use landing gear to lift your trailer or RV during tire changes or service work because doing so will exceed the capacity of the landing legs. Specially designed to level and stabilize your trailer or RV, each of these jacks provide simple, effective leveling.
Why is my landing gear not lifting up?
Thanks. Any powered landing gear or powered tongue jack will draw less power as it legs descend down toward the ground and much more as soon as they make contact and encounter resistance. This is a normal occurrence.
How to troubleshoot a fifth wheel landing gear problem?
I’m troubleshooting a landing gear problem on a fifth wheel. When I extend the landing gear the motor seems to make a skipping sound and has a hard time raising the trailer. I’m trying to determine if there is a gear box problem or a motor problem. I believe the legs are not bent, and there is no rear end jacks down.
Why does my landing gear make a skipping sound?
When I extend the landing gear the motor seems to make a skipping sound and has a hard time raising the trailer. I’m trying to determine if there is a gear box problem or a motor problem. I believe the legs are not bent, and there is no rear end jacks down. Can you give me advice in determining where my problem is? Submitted: 9 years ago.
Where can I find the Atwood Jack manual?
Go HERE for the Atwood Jack Manual which has all the measurements in there. The clutch mechanism is in the gearbox on the motor. Get back to me with what you find.
