How are these basement steps typically setup to drain?
My basement has an outdoor entrance. There is a set of steps that go from that outside entrance up about 6 feet to ground level. At the base of the steps there is a landing with a drain in it and the drain no longer works. How are these basement steps drains typically setup?
What should the slope of a drain pipe be?
To do this you will also need a line level, which is a little level available at any hardware store, that hangs on your string. All of your drain pipe (with one exception) must slope slightly downhill. Usually 1/8″ per foot is plenty for drainage, this is the same as the commonly recommended 1% slope.
What should the bottom of a foundation drain be?
At the highest point, the bottom of the drain rock bed and the bottom of the tile might be about mid-footing height. Knapp replies that the foundation drain should be level with the foundation and routed to daylight. “The idea seems to be to provide an easy way for the water to move away from the foundation,” he says.
How tall are the steps to the basement?
There is a set of steps that go from that outside entrance up about 6 feet to ground level. At the base of the steps there is a landing with a drain in it and the drain no longer works. How are these basement steps drains typically setup?
My basement has an outdoor entrance. There is a set of steps that go from that outside entrance up about 6 feet to ground level. At the base of the steps there is a landing with a drain in it and the drain no longer works. How are these basement steps drains typically setup?
Where does the buried downspout drain line go?
The buried downspout drain line shown at left is one that we’d recommend abandoning – it connects to a drain line that enters the building through the foundation wall and passes below the basement floor, incorporating a basement floor drain, ultimately connecting the the sewer line.
How to install EZ1 slab on grade floor drain?
1. Cut pipe so that the height of the finished drain is at or just below the height of the finished floor. (See Zurn Engineering Handbook or EZ1TMSubmittal for dimensional heights). Ensure pipe is cut square and free of burrs or debris. See Fig. 1 2. Solvent weld drain body on pipe and pressure test connection per local code requirements.
To do this you will also need a line level, which is a little level available at any hardware store, that hangs on your string. All of your drain pipe (with one exception) must slope slightly downhill. Usually 1/8″ per foot is plenty for drainage, this is the same as the commonly recommended 1% slope.
