Does a washer need a 2 drain?
A 2-inch drain pipe is required for all washing machines. The former requirement of 1 1/2-inch pipe is not enough to handle the fast drainage of modern washers. As with all plumbing fixtures and appliances, a washing machine drain pipe must also contain a P-trap.
Is it bad for a washer to sit unused?
If stored properly under the right conditions, a washer can sit unused for months or even years, and when it starts operating, it will do just fine. However, if not stored properly such as by draining all the water, it can start rusting, and if stored for extended periods, it will sustain irreversible damage.
How do you move a drain line for a washing machine?
Glue a P-trap to the drain at the location of the washer. The bottom of the trap should be 12 inches from the floor. Glue a vertical length of 2-inch pipe to the trap opening and extend it at least 2 feet above the bottom of the trap. This is the drain standpipe.
Can you put Drano down a washing machine drain?
Can I put Drano down my washing machine drain? Yes. Drano or any drain cleaner can be used to unclog your washing machine drain, but make sure you run your washer without a load of laundry before normal use.
Can a washing machine drain into a sink?
Automatic clothes washers that discharge by gravity shall be permitted to drain to a waste receptor or an approved trench drain. Your upper sink can be 2 inch but where the washer sink drain’s into the tee it must increase to 3 inch pipe size. FIXTURE DRAIN. The drain from the trap of a fixture to a junction with any other drain pipe.
How tall does the drain pipe have to be for a washing machine?
DFU’s for washing machines and kitchen sinks vary per code. Also, suds relief code comes into play with fixtures such as washing machines. c)Washer trap must be 6″ above the floor.
Glue a P-trap to the drain at the location of the washer. The bottom of the trap should be 12 inches from the floor. Glue a vertical length of 2-inch pipe to the trap opening and extend it at least 2 feet above the bottom of the trap. This is the drain standpipe.
Can a washing machine drain into a toilet?
The washing machine drain (1.5″) would run horizontally along wall, pick up the lavatory drain (still 1.5″) and wye into a 2″ drain with the shower, which then wyes into a 3″ drain with the toilet and on to a sump. This install is in a basement, so it would be very difficult to cut more concrete or run a separate line to the sump.
Is it OK to have two washers on one drain?
Nowadays, the machines don’t use much water so it maybe not an issue so much. In fact, the newer machine we have doesn’t always get my clothes clean! Thanks for the information, just finished discussing this with the plumber, found out there’s no stack, they were trying to drain into an abandoned 2-inch shower drain connection.
How big of a drain do you need for a washing machine?
Washing machine drains today, in at least most jurisdictions, are 2″ because of the higher pump-out capacity on new washers, bathroom sinks 1-1/2 or sometimes 2″, toilets always minimum 3″, tubs 1-1/2 or sometimes 2″, showers 2″, main stack or collector branch 4″.
