Do you have to connect the drain to the tub?
It needs to line up perfectly, otherwise it will be impossible to make a water tight connection. However, if you have easy access to underneath the bathtub, then it may be easier to first connect the drain assembly to the tub, install the tub, and then connect the plumbing to the house as a final step.
How do you install a tub overflow drain?
Thread the linkage through the overflow hole if you have a lever drain. If you’re installing a lever-style drain, insert the plunger and linkage into the hole in the tub wall beneath the faucet. Feed it into the overflow pipe, screw the overflow faceplate onto the opening, then screw the new drain plate onto the flange.
What’s the best way to install a new bathtub?
Then, slowly lower the bathtub into place, being careful not to smear the silicone sealant. Then, put another large bead of silicone on the underside of the drain flange and then screw in the drain to the threaded elbow. Then put on the cover plate for the overflow drain.
How do you replace a drain basket in a tub?
When the tub shoe is lined up and the washer is in place, hand screw the drain basket into the tub shoe. If your original drain basket was damaged during removal or it is corroded beyond reuse, replace it with a PVC drain basket. Tighten down the drain pipe nut around the extension pipe.
It needs to line up perfectly, otherwise it will be impossible to make a water tight connection. However, if you have easy access to underneath the bathtub, then it may be easier to first connect the drain assembly to the tub, install the tub, and then connect the plumbing to the house as a final step.
How to fix a plunger drain in a bathtub?
How to Fix a Plunger Bathtub Drain 1 Remove the Drain Components. Take out the screws on the cover plate and pull it away from the tub wall. 2 Clean the Drain Components 3 Lubricate the Drain Components 4 Adjust the Flow Rate
What should I do if my bathtub overflows?
Flush the tub drain and overflow drain with a solution of 1 cup of vinegar and 1 cup of baking soda. Rinse with boiling water. Lubricate the plunger and linkage, and reinstall them into the overflow drain. Partially fill the tub and check to see if the drain holds water. Then open the drain and check the flow rate.
Then, slowly lower the bathtub into place, being careful not to smear the silicone sealant. Then, put another large bead of silicone on the underside of the drain flange and then screw in the drain to the threaded elbow. Then put on the cover plate for the overflow drain.
