Do you backwash after vacuuming?
Yes, we recommend backwashing after you vacuum your pool. This allows the filter to shoot out any dirt / debris you have vacuumed up. Don’t forget to set your filter to “rinse” for 30 seconds after backwashing!
What is the waste function on my pool filter?
Waste. This setting draws water from the pool and sends it straight to the waste outlet without passing through the filter. You would use the ‘Waste’ setting to drain or partially drain your pool or you may use it when vacuuming if there is a lot of dirt and debris on the bottom of your pool.
What’s the best way to vacuum a swimming pool?
Step 3: Choose your filter valve setting. For light vacuuming, you can leave your multiport valve filter set to “Filter.” For bigger jobs and larger amounts of debris, set your filter system to the “Waste” setting, which does sends the water down the drain, rather than through the filter.
Where does the vacuum head go on a pool filter?
This will fill the hose with water. Leave the hose in the water, place the vacuum head to the end of the hose, and then connect to the filter suction end. You should notice the hose sink into the pool and the vacuum head rest at the bottom of the pool.
Is it OK to vacuum a pool with a cartridge filter?
The greater the water flow in your pool’s system, the faster the wheel rotation on the vacuum unit will be. Too fast, and the vacuum will not clean effectively; too slow, and there is a risk of damage.
How do you clean a sand filter in a pool?
If your pool uses a sand filter, the following are the steps. 1. Remove Large Leave or Debris. Before you begin to vacuum, use a scoop net to remove any particularly large leaves or debris that might otherwise block the vacuum head or hose pipe. 2. Attach the Vacuum Head to the Telescopic Pole and Hose Pipe.
The greater the water flow in your pool’s system, the faster the wheel rotation on the vacuum unit will be. Too fast, and the vacuum will not clean effectively; too slow, and there is a risk of damage.
This will fill the hose with water. Leave the hose in the water, place the vacuum head to the end of the hose, and then connect to the filter suction end. You should notice the hose sink into the pool and the vacuum head rest at the bottom of the pool.
How do you put a vacuum in a pool?
Connect the vacuum hose to the vacuum head (already attached to a pole of course) and lower it into the pool. Expel the air from the hose and connect to the skimmer port. See my post How to remove air from a vacuum hose to find out how to do this.
What’s the best way to clean a pool filter?
Flood the Hose Pipe With Water. Submerge the hose and allow it to flood with water. The point is to remove trapped air that may otherwise be drawn into the pump and create an air block. Pro tip: hold the hose next to the return outlet to quickly fill the hose with water. 4. Attach the Hose Pipe to the Skimmer or Dedicated Suction Port.
