Can you leave Spa empty?
Keep in mind, we strongly recommend that you never leave your spa empty for a period of 2 weeks or more. Leaving your spa empty can cause damage to the pumps, heater element, and shell.
When to turn off the heater in a spa?
The Hi-Limit shuts off the heater or spa equipment when it detects a water temperature of 109° – 116°. The Hi-Limit on most newer spas can be reset by turning off the spa’s main power supply, and allowing the water to cool to below 100°.
What’s the reset button on an old spa?
Older spas used mechanical Temperature and Hi-Limit switches. This type of Hi-Limit can usually be reset by pushing in its reset button, a red or black button located on the heater or equipment pack (see your spa manufacturer’s instruction manual for exact location on your spa).
How to troubleshoot an issue with your spa?
To troubleshoot an issue with your spa, locate your specific problem in the chart below to help determine a probable cause, and then apply the right solution. Do you need to call a professional technician? Do you need to call a professional technician? Adjust the total alkalinity and pH.
How to get a hot tub to exit SL sleep mode?
On them you need to press the ‘TEMP’ button and then the ‘LIGHT’ button within three seconds of each other and this will change the modes from EC (economy mode), to SL (sleep mode) and finally to ST (standard mode) which is what you want. Read full interaction below » Ask Your Own Pool and Spa Question Share this conversation Resolved Question:
Older spas used mechanical Temperature and Hi-Limit switches. This type of Hi-Limit can usually be reset by pushing in its reset button, a red or black button located on the heater or equipment pack (see your spa manufacturer’s instruction manual for exact location on your spa).
How to troubleshoot hot tub and spa equipment pack?
Using volt meter on a minimum 240 volt scale (120 on a 120 pack) check to see whether the power coming in is enough to power the pack: 210-240 on 240v, 110-120 on 120v. If not, have an electrician look into it. 5. On 240v observe contactor or heater relay.
The Hi-Limit shuts off the heater or spa equipment when it detects a water temperature of 109° – 116°. The Hi-Limit on most newer spas can be reset by turning off the spa’s main power supply, and allowing the water to cool to below 100°.
What to do if your hot tub is not in summer logic?
Also check to see that your spa is not in Summer Logic (spa water reaches 2 DEGREES above the set temperature). If your spa is in Summer Logic, cool the water off by opening the cover and or adding some cold water to the spa. If neither of these are the case you could have a bad Flow Switch or a bad connection to the Flow Switch.
