Can a pool pump be used with salt water?
When a pool pump talks about not being compatible with saltwater, or most pool equipment for that matter, this is actually referring to sea water systems and not salt water chlorine generators.
Why do I need to change the speed of my salt pump?
If you set your variable speed pump at a certain speed in order for your salt system to turn on and run, you may need to change this value as the filter becomes more dirty. For a given motor RPM you will move less water through a system with a dirty filter than one with a clean filter.
What should I do if I Hear my pool pump filling?
You should hear water filling the tank or, if you have a water pressure gauge, notice the level rising. On a pool pump, fill the strainer basket and close its lid. Turn off the water to the hose. Once you see water coming out the opposite end, you can turn off the turn off the water to the hose.
Why is the air coming out of my pool pump?
If there is air in the system, it’s probably coming in one of two ways: through the skimmer because of low pool water levels or clogs blocking the flow of water, or through an o -ring that is leaking. If your swimming pool level is low, the problem can usually be fixed by filling it up.
If you set your variable speed pump at a certain speed in order for your salt system to turn on and run, you may need to change this value as the filter becomes more dirty. For a given motor RPM you will move less water through a system with a dirty filter than one with a clean filter.
When a pool pump talks about not being compatible with saltwater, or most pool equipment for that matter, this is actually referring to sea water systems and not salt water chlorine generators.
Why is my water pump not working properly?
Remove the debri and reposition the hose to start pumping again. The intake filter or screen can also be the culprit even without debri . While you must ensure the filter is fine enough to prevent damaging solids from entering the pump, too fine a filter for the water pump will restrict the flow right as the water enters the intake.
What does it mean when your water well starts to pump sand?
If your water well suddenly starts to pump sand, this is often a sign that the well is silting in or filling with sand and silt. Typically, the well pump is installed, so it is at least 10 – 20 feet above the bottom of the well. When the pump turns on, the water level in the well can drop to a lower level.
