Can a Hayward pool pump be replaced by a Sta Rite pump?

Can a Hayward pool pump be replaced by a Sta Rite pump?

Sta-Rite SuperMax pumps are a direct replacement for the Hayward Super Pump! Sta-Rite SuperMax pumps feature thick-walled body parts, a heavy-duty square flange motor, and highly engineered hydraulics. Silent running capability and small footprint allow it to easily drop into a compact equipment pad.

Is the Sta Rite supermax pool pump commercial grade?

NSF Approved, the SuperMax Pump moves water efficiently for low operating cost and quiet operation. You get less wear and tear, and that means longer life and a higher return on your pump investment. Commercial grade, heavy-duty 56 square flange motor.

What to do if your pool pump does not fill?

If your pump basket does not fill with water, you’ll have to prime the pump. The good new is it’s pretty straight forward, just follow the steps below: Disconnect any power to the pump and move the diverter valve so that the main drain side is turned to off.

Why does my pool pump keep running with rocks in it?

If your pool pump sounds like it’s running with rocks inside the pump basket, it might be starved for water. This can be attributed to a couple of different things. First, check your suction lines. If too many of them are closed off, the pump will struggle to get water and become noisy. Next, check your skimmers.

What should I do if my pool pump is not primed?

If water is not flowing freely in the strainer box, return to step one and repeat. Switch the diverter valve back to half way between the skimmer and main drain. If the pump is still not primed, check the impeller for debris and filter pressure for anything 10psi above the clean reading for your pool filter.

How can I check if my pool pump is air tight?

To check the impeller, turn the power off to the pump and remove the screws in the middle of the pump body. Once the screws have been removed, pull the assembly out of the housing and remove the gasket away from the impeller, remove any debris and re-assemble. To operate properly, pool pumps must be air tight.

If your pool pump sounds like it’s running with rocks inside the pump basket, it might be starved for water. This can be attributed to a couple of different things. First, check your suction lines. If too many of them are closed off, the pump will struggle to get water and become noisy. Next, check your skimmers.

What do I need to take my pool pump apart?

Before taking apart your pool pump, we recommend purchasing a go-kit. It is relatively inexpensive and will have all the necessary parts to replace your worn o-rings and seals. If your pump basket does not fill with water, you’ll have to prime the pump.

You Might Also Like