Can a failing cell still read low salt levels?
It’s common for failing cells to read lower salt levels. If it’s 6 years old I’d suspect the cell. Alright, so salinity is measured by temp, voltage, and amperage. This cell still generates and when it does the voltage/amp readings appear normal so what about meddling with the temp sensor?
How to fix Zodiac Jandy ei aquapure salt system?
How to fix a Zodiac Jandy Ei salt system cell with a no flow and yellow light blinking. Just make sure to clean pump strainer and filter to make sure the water is flowing through the cell and make sure you turn off the electricity before doing any repairs.
Why does my Jandy pool have no flow?
An old problem has come back again. No Flow with the Jandy Aquapure Handheld and the LCD panel one green light on and no error codes which I used to get in the past. The sensor is only about a year and a half old. The Chlorine cell is about 4 years old.
How old is the no flow sensor on Jandy aquapure?
The sensor is only about a year and a half old. The Chlorine cell is about 4 years old. I cleaned the cell (some build up but not bad at all just a light coating). Polished the sensor and still nothing. THe Chloirine level has been droppinng to next to nothing over the week before I noticed the no flow and cleaned the cell.
It’s common for failing cells to read lower salt levels. If it’s 6 years old I’d suspect the cell. Alright, so salinity is measured by temp, voltage, and amperage. This cell still generates and when it does the voltage/amp readings appear normal so what about meddling with the temp sensor?
Why does my Jandy aquapure have no flow?
My Aquapure sensor was less than one year old and it started reading “No Flow”. I replaced the filter (it was time, anyway), cleaned the trap, scrubbed the sensor, inspected the salt cell, increased the RPMs, powered down & restarted the system, and just about every other troubleshooting trick I could find.
When to add salt to a salt cell?
If value is not reading within 500ppm of independent test, then replace cell. If number is reading within 500ppm of the independent test and the ‘Inspect Cell’ LED is flashing, add salt until level is above 2700ppm. The ‘High Salt’ LED will be ON when the cell amperage is above the maximum limit.
When does the check salt and inspect cell flash?
The ‘Check Salt’ & ‘Inspect Cell’ LEDs will flash when the cell reports the salt level is between 2400 – 2700ppm. In this condition chlorine is still being produced. The ‘Check Salt’ & ‘Inspect Cell’ LEDs will be ON when the cell reports the salt level is 2300ppm or less.
