Can a driver side slide be retracted on a disco?
If neither of these are possible they say the slides should be moved only with fully charged batteries. On the Disco, the driver side slide fits flush to the floor when extended. The three men are getting it over the ramp to retract. There is a replacement motor with higher torque available.
Why is my passenger side slide not retracting?
My trip to Baton Rouge for LSU football this past weekend went to heck when my passenger side slide would not retract (we stayed Thursday night in Lake Charles, LA to visit my son’s family). After calling a couple of Lake Charles RV repair shops, the initial thought was the slide motor had quit working.
Where are the slide controllers on a coach?
Different coach but my slide controllers are behind a panel that holds my cable/sat input in one of the bays. I have electric motors also that look identical to yours. Mine are Kwikee but like stated all owned by Lippert now. On my motors there is a 3/4 inch nut and also on the motor is a “lock” switch.
What are the common problems with fifth wheel slide outs?
Each slide-out operating system has its own unique problems. Check out the following common problems with slide-outs on a fifth wheel. A faulty motor or gearbox could be the problem if your RV slide-out gear system is motor-driven. In such cases, if the motor is faulty or breaks down, then the mechanism will not work.
What are the features of an encore Coachmen RV?
Spacious and stacked with amenities, it has everything you need to relax and recharge. That includes stainless steel appliances, 15,000 BTU ACs, king bed, drop down cab-over bunk, and more standard features than ever before. Slide Outs?
How can I fix this coachmen slide out?
KevinS121 Some college 952 satisfied customers 2020 coachmen prism slide out won’t open. It keeps catching 2020 coachmen prism slide out won’t open. It keeps catching on one lower corner and won’t extend properly. This RV is brand new and we’ve only had it 6mos.
My trip to Baton Rouge for LSU football this past weekend went to heck when my passenger side slide would not retract (we stayed Thursday night in Lake Charles, LA to visit my son’s family). After calling a couple of Lake Charles RV repair shops, the initial thought was the slide motor had quit working.
Different coach but my slide controllers are behind a panel that holds my cable/sat input in one of the bays. I have electric motors also that look identical to yours. Mine are Kwikee but like stated all owned by Lippert now. On my motors there is a 3/4 inch nut and also on the motor is a “lock” switch.
Is there a replacement motor for a disco slideout?
All disco owners are in sympathy with you and would all say the replacement motor is worth the $. On the Disco, the driver side slide fits flush to the floor when extended. The three men are getting it over the ramp to retract. There is a replacement motor with higher torque available.
What’s the best way to retract slideouts?
Every seminar I have attended says to always operate the slides at road level, which means to put them out before leveling the coach and bring them in after raising the jacks. This sets the coach “true” so the slides are not “torqued”, which can cause binding and damage.
If neither of these are possible they say the slides should be moved only with fully charged batteries. On the Disco, the driver side slide fits flush to the floor when extended. The three men are getting it over the ramp to retract. There is a replacement motor with higher torque available.
All disco owners are in sympathy with you and would all say the replacement motor is worth the $. On the Disco, the driver side slide fits flush to the floor when extended. The three men are getting it over the ramp to retract. There is a replacement motor with higher torque available.
Every seminar I have attended says to always operate the slides at road level, which means to put them out before leveling the coach and bring them in after raising the jacks. This sets the coach “true” so the slides are not “torqued”, which can cause binding and damage.
Why do I have trouble retracting my slideout?
I don’t know a lot of the details, but it turned out that at the end of the stroke, the slide out dropped so that one of the rack and pinion sets changed center distance enough that the gear teeth disengaged. The retracting load would then fall on only one set of gears thus causing the slideout to skew and bind.
Why does my forest river slide not retract?
Storiing fishing poles from the other side, the metal ends of the pole shorted the P/C board. As always, this will happen when the slide is extended. Ditto for Forest River’s RVs. Level first, extend slides afterward.
Why does my Damon intruder slide not retract?
Storiing fishing poles from the other side, the metal ends of the pole shorted the P/C board. As always, this will happen when the slide is extended. I own a 2003 Damon Intruder.
Are there any problems with the slide out on an RV?
Troubleshooting RV Slide Out Problems: One main problem with slide outs is that they may get out of alignment. The good news here is that each slide can be adjusted separately. All you have to do to fix it is take your RV to a dealer and let them make an adjustment.
I don’t know a lot of the details, but it turned out that at the end of the stroke, the slide out dropped so that one of the rack and pinion sets changed center distance enough that the gear teeth disengaged. The retracting load would then fall on only one set of gears thus causing the slideout to skew and bind.
Storiing fishing poles from the other side, the metal ends of the pole shorted the P/C board. As always, this will happen when the slide is extended. Ditto for Forest River’s RVs. Level first, extend slides afterward.
Why does my slide not retract after new motor?
After the new motor was installed, the slide still would not retract. The “square rods” connected to the motor were detached to assure the new motor was functioning. We found that power to the motor existed only when the “out” part of the slide’s in/out button was pushed. There was no power to the motor when the “in” side of the button was pushed.
After the new motor was installed, the slide still would not retract. The “square rods” connected to the motor were detached to assure the new motor was functioning. We found that power to the motor existed only when the “out” part of the slide’s in/out button was pushed. There was no power to the motor when the “in” side of the button was pushed.
How do you align slide out drive shaft?
Tap on that lightly with a mallet while sliding the drive shaft if necessary. Disengaged slide-out rail gear. Once the idler rail gear is off the rack, both rails can be synchronized by manually moving the disengaged side until the room is aligned properly.
What’s the override nut on an RV slide out?
The nut shown at right is the manual override nut for manually moving the slide in the event of motor failure. Tap on that lightly with a mallet while sliding the drive shaft if necessary. Disengaged slide-out rail gear.
Where is the drag link on a discovery?
Watch Jim in this video as he gives a brief discussion of the location of the track rod and drag link for a Discovery Series II, 1999 – 2004. It is the same for the Range Rover P38, 1995 – 2002.
Tap on that lightly with a mallet while sliding the drive shaft if necessary. Disengaged slide-out rail gear. Once the idler rail gear is off the rack, both rails can be synchronized by manually moving the disengaged side until the room is aligned properly.
Is it OK to operate drivers side slide?
My owner`s manual states that you should NOT operate the slides until the motor home is level to avoid binding and other damage to the slides. Also, I found out the hard way that the drivers side slide has a motor control board that is riveted upside down in the motor compartment.
Can a Damon intruder slideout be torqued?
This sets the coach “true” so the slides are not “torqued”, which can cause binding and damage. I own a 2003 Damon Intruder. My owner`s manual states that you should NOT operate the slides until the motor home is level to avoid binding and other damage to the slides.
This sets the coach “true” so the slides are not “torqued”, which can cause binding and damage. I own a 2003 Damon Intruder. My owner`s manual states that you should NOT operate the slides until the motor home is level to avoid binding and other damage to the slides.
Why is my drivers side slide out on my Bounder 35R?
I just bought a 2004 Bounder 35R. When I got it the drivers side slide went out and wouldn’t go back in. The dealer said a “shear pin” was broken and the other one was coming loose. They replaced both and lubricated the slide.
What causes a slide out to not retract?
With that being said, the biggest issue with slide-outs doesn’t have anything to do with the extension/retraction process. It has to do with seals, the rubber gaskets that surround a slide-out and keep the elements at bay. Improperly installed seals can pull loose and affect movement of the slide.
What to do if your slide out slides are crooked?
To solve this issue, you can remove some of the carpet and replace it with slide out slickers. Or you can shim your slide out slides with thing, 1/4” thick, aluminum flat stock. With the latter method you can interchange the metal and thickness to fit your situation.
What does it mean when slide outs don’t slide?
This will indicate whether the problem may be the batteries or not. If you push the button for the slide outs and can hear the motor running but the slides don’t move, check the motor’s shear pins. Although it’s pretty rare, there’s a chance they could both be broken.
Can a single pump be used to retract slide outs?
In either instance you will probably find yourself at the mercy of an RV repairman, who may or may not have the parts needed for a quick repair on hand. Also, due to the inherent power of hydraulics, a single pump/motor is often used to extend/retract all slide-outs. When it works, you’re golden.
What to do when your RV slide is not coming in?
RV Slide not Coming in (Retracting) When this situation takes place and before you move to the manual over ride system, check the control switch to see if it is working properly. Then check to see if you have enough power to the pump. If you do not get any power at the pump then you need to replace the switch.
What kind of RV is the Beaver Patriot?
2009 BEAVER PATRIOT THUNDER PRINCETON 4 PRINCETON IV, This 2009 Patriot Thunder is a elegant fine tuned class A motorhome. The craftsmanship in this… Beautiful 2002 Be… Beautiful 2002 Be… 2002 Beaver Patriot Princeton, Stock #236984 – Beautiful 2002 Beaver Patriot Princeton with only 42,000 miles! Well built, High end, Luxury RV! Wel…
