Can a bulldozer slide out of the dirt?
If you’ve ever marveled at the ability of a bulldozer to easily pick up thousands of pounds of dirt, you’ve witnessed hydraulics at work. This massively robust approach makes light work of slide-out movement, which (theoretically, at least) leads to long life and relatively few problems.
Are there any problems with the slide out on an RV?
Troubleshooting RV Slide Out Problems: One main problem with slide outs is that they may get out of alignment. The good news here is that each slide can be adjusted separately. All you have to do to fix it is take your RV to a dealer and let them make an adjustment.
Why is my slide out not working on my car?
To get back home to Katy, the power supply wires to the motor were “reversed” so the slide could be retracted so I could drive home to Katy, TX. With the power supply wires “reversed”, the slide will now not extend.
Why does my rear suspension make a grinding noise?
Creaking or grinding noises usually mean something metal is rubbing against something else that’s metal, indicating a bad ball joint, end link, or rubber coil spring isolator. Sharp popping noises may indicate that something is either broken or so worn that it’s causing the suspension to bind up.
Troubleshooting RV Slide Out Problems: One main problem with slide outs is that they may get out of alignment. The good news here is that each slide can be adjusted separately. All you have to do to fix it is take your RV to a dealer and let them make an adjustment.
To get back home to Katy, the power supply wires to the motor were “reversed” so the slide could be retracted so I could drive home to Katy, TX. With the power supply wires “reversed”, the slide will now not extend.
What are the colors of the slide out switch?
It makes sense that there is a relay somewhere as the wires on the back of the slide out control switches are different colors (orange “slide in” wire, blue “slide out” wire, and a common purple wire for all three switches). Somewhere the orange and purple wires at the control switch change to green and yellow wires at motor.
Why does my slide not retract after new motor?
After the new motor was installed, the slide still would not retract. The “square rods” connected to the motor were detached to assure the new motor was functioning. We found that power to the motor existed only when the “out” part of the slide’s in/out button was pushed. There was no power to the motor when the “in” side of the button was pushed.
