Can a Balboa water group heater be replaced?
Balboa Water Group does not warranty any such replacements and any replacement voids the warranty of any Balboa Water Group component currently installed on the spa. SPA HEATER ELEMENT REPLACEMENT POSES A SAFETY RISK!
How to get technical support for Balboa direct?
Disconnect all the components (i.e., pumps, blower, ozonator heater) and plug them back in one at a time to verify which component is causing the GFCI to trip. 3.
What to do when there is no error message on Balboa?
If there is No Error Message, Select “No Error Message” Below. If there is Now an Error Message, select Message Other than CFEor CONFIG ERROR below or contact your Dealer or Service Organization. The “CFE” or “CONFIG ERROR” Configuration Error Appears to have been Corrected or is Intermittent.
Where can I buy a Balboa SPA system?
This site is an extension of that one stop shop, and is the only factory direct store selling genuine Balboa products. With Balboa Direct you can purchase online at your convenience without having to go through another source or distributor. Whether you order a single part or a system, your order is shipped directly to a location of your choice.
Do you need a Balboa spa control system?
Balboa Direct provides cutting edge, reliable, high value control systems that Balboa Water Group has been known for. Whether you are looking to purchase a retrofit kit, a Balboa spa control system, or need replacement parts on your existing spa control system, you can buy with confidences knowing that Balboa has the right system pack for you.
Is there a relay fault in my Balboa spa?
4. If there is water circulation immediately after you have restored the power to your Spa (without pressing any buttons) and the Jets’ Indicator Light remains OFF, a Relay Fault in the Control System has been confirmed. To have the issue resolved, a new Balboa BP501 Control System would need to be installed.
Is there an issue with the Balboa bp501 system?
If your Spa seems to be running the low speed of the pump for extended periods of time (more than 2 hours or continuously) and you have confirmed the Filtration Cycles are currently set to run for 2:00 hours only, there might be an issue with the Balboa BP501 Control System.
Why is the Jets indicator light off on my Balboa pump?
Usually you will also notice the Jets’ indicator light remains off even when the Pump is running the low speed (indicator light should always be ON when the Pump is running) and if you press the Jets’ button, a humming noise can be heard and the Pump will completely shut off.
